[p4] Request too large from p4 changes

Stephen Vance steve at vance.com
Thu Feb 21 13:55:40 PST 2008


These parameters are in the group memberships. You get the highest value 
from all the groups you are in. The parameters are MaxResults, 
MaxScanRows, MaxLockTime, and Timeout. The maxresults help page 
describes all of them.

Steve

Thierry Lam wrote:
> I'm trying to find out what the last 5 changes were from a specific location on the depot, for instance::
>
> p4 changes -m5 //depot/main/hello/...
> Request too large (over 400000); see 'p4 help maxresults'.
>
> I get the above message, however the above works fine with -m1 but anything greater than 1 fails.  The same p4 changes -m5 command works elsewhere on the depot, does anyone know if there's a perforce mechanism which  controls this behaviour?
>
> Thierry
>
> _______________________________________________
> perforce-user mailing list  -  perforce-user at perforce.com
> http://maillist.perforce.com/mailman/listinfo/perforce-user
>
>   

-- 
Stephen Vance
www.vance.com



More information about the perforce-user mailing list